[912paintballer]

I have a led and it needs a charging plug. I have the correct battery charger and battery. My hold up is the 3 hole port in the back. I seen a image showing the positive and negative post but need help figuring out how to wire the male end to make it charge. I have the components to make a male end I just don't want to plug wires in the wrong area and damage any of the electrical parts. Obviously I tried the positive and negative hole with the charger and it shows nothing I think I need to tie in the third post to something. Any help is appreciated.

[Roger7pball]

I can’t take credit for the hand drawn picture - saved it long ago. Maybe these will help you? The third pin is for the hopper with intellifeed, not needed for charging. Keep in mind the Angel LCD needs to be on while charging while the LED needs to be off.

[912paintballer]

Thanks

[dr.strangelove]

Should you need an offline copy of the wiring diagram posted above, it is also in the Angel LED FAQ and Diagrams PDF document in the Manual/Tech Repository thread