Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

Reply
 
Thread Tools
Old 10-22-2019, 09:00 PM #1
Mr. Red
CO2 Extraordinaire
 
Mr. Red's Avatar
 
Join Date: Sep 2012
Location: Missouri
Mr. Red has achieved Level 3 in PbNation Pursuit
Mr. Red supports Ninja Paintball
Angel LCD trigger pin - where to get one?

Hello. Purchased a DYE single trigger LCD frame off of ebay and it does not come with a trigger compression pin to keep the trigger installed. Does anyone know of a source location for one?

Any help would be appreciated. I really don't want to remove the original trigger pin, from the double trigger lcd frame, if I don't have to.
Mr. Red is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Advertisement
Old 10-22-2019, 09:05 PM #2
euphoria526
ZelRolFox's given
 
euphoria526's Avatar
 
Join Date: Oct 2001
Location: The SFV.
 has been a member for 10 years
 is playing at Living Legends XI
euphoria526 has achieved Level 1 in PbNation Pursuit
euphoria526 has achieved Level 2 in PbNation Pursuit
http://www.angelpaintballparts.com/

Check here first and see if they have it. Otherwise put it up in the wtb section in the APS section
__________________
Old School Baller
euphoria526 is offline   Reply With Quote
Old 10-23-2019, 11:29 AM #3
Mr. Red
CO2 Extraordinaire
 
Mr. Red's Avatar
 
Join Date: Sep 2012
Location: Missouri
Mr. Red has achieved Level 3 in PbNation Pursuit
Mr. Red supports Ninja Paintball
Found a post that indicated it's supposed to be a 3mm pin. If that is the case, if I can't locate one, I likely can just make one out of the smooth back end of a 3mm drill bit. If that fails, a roll pin should fix the problem.
Mr. Red is offline   Reply With Quote
Old 10-25-2019, 03:37 PM #4
dr.strangelove
The Angel Eye Doctor
 
dr.strangelove's Avatar
 
Join Date: May 2003
Location: Earth
 has been a member for 10 years
Quote:
Originally Posted by Mr. Red View Post
Found a post that indicated it's supposed to be a 3mm pin. If that is the case, if I can't locate one, I likely can just make one out of the smooth back end of a 3mm drill bit. If that fails, a roll pin should fix the problem.
This is indeed the easiest solution. I can confirm the pin is 3mm diameter x 18mm length for the LCD (the IR3 and newer pins are shorter). A short piece of 3mm bar stock will also work - just trim to length.
dr.strangelove is offline   Reply With Quote
Old 10-25-2019, 04:33 PM #5
Mr. Red
CO2 Extraordinaire
 
Mr. Red's Avatar
 
Join Date: Sep 2012
Location: Missouri
Mr. Red has achieved Level 3 in PbNation Pursuit
Mr. Red supports Ninja Paintball
Just an update. Found a dowel pin at the local ACE hardware. Bought it and worked/sanded the pin down for a custom sized fit. Works flawlessly.
Mr. Red is offline   Reply With Quote
Reply


Thread Tools

Posting Rules
Forum Jump