Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

Reply
 
Thread Tools
Old 05-02-2019, 08:27 PM #1
T.O.G Lance
 
 
T.O.G Lance's Avatar
 
Join Date: May 2019
I'm in the process of constructing a double barrel arm gun, using 2 Azodin 2011 Blitz markers. I extended some of the circuit board wiring. The main problem I'm having is that one of the fireing solenoides is not fully engaging. After the wire modification on both solenoides only one solenoid retained the same strength. I have tried multiple batteries and nothing has changed.

Last edited by T.O.G Lance : 05-02-2019 at 08:44 PM.
T.O.G Lance is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Advertisement
Old 05-02-2019, 10:42 PM #2
- Falcon -
 
 
Join Date: Apr 2019
- Falcon - owns a Planet Eclipse CS2
Maybe use a separate power source for each. Then use an optocoupler off the mainboard to the solenoid board of the second gun via optocoupler?

People much smarter than I will ever be over on EEVBLOG.com. Should get the help you need over there.

Last edited by - Falcon - : 05-02-2019 at 10:56 PM.
- Falcon - is offline   Reply With Quote
Old 05-07-2019, 04:42 AM #3
StoneDwarf
 
 
Join Date: May 2018
So you are using both boards, each engaging its own solenoid and powered up by separate battery.
In this case the problem should be in that particular solenoid.
If you are trying to activate two solenoids simultaneously from one board, one of them will lack power obviously.
You will have to make custom board to operate them.
StoneDwarf is offline   Reply With Quote
Reply


Thread Tools

Posting Rules
Forum Jump