aardy tricked trix vs LCD trix - PbNation
Find fields & stores near you!
Find fields and stores
PbNation News
PbNation News
Community Focus
Community Focus

Archived Thread - Cannot Edit  
Old 05-14-2002, 05:40 PM #1
youre joking, right?
xXx's Avatar
Join Date: Mar 2002
Location: on the field
 has been a member for 10 years
aardy tricked trix vs LCD trix

hey guys,

i dunno if this question has been asked or not....
should i get a stock matrix and trick it out with the aardy stuff or get an LCD? i know that they come with the tirnity clone and bolt kit but, ive heard that PBC/TMC stuff is prone to failure. broken microswitches, bad solenoids, boards etc....

On the other hand... a stock matrix with an alligator trigger trinity red bolt kit low rize and bullet volumizers.

i dont know if i wanna buy the LCD and end up replacing the parts eventually with aardy stuff. but h#ll, i may just buy the LCD take out the TMC stuff and put aardy in, if i do that ill be selling the PBC stuff brand new.

i was just wanting some feedback, and ppl with experience with both the products to tell me how TMC stacks up to Aardy.

Team xXx
xXx is offline  
Old Sponsored Links Remove Advertisement
Old 05-14-2002, 05:56 PM #2
MATRIX (Banned)
MATRIX's Avatar
Join Date: Feb 2002
Location: Southeast
 has been a member for 10 years
its not TMC's fault of bad microswitches (this is done by ppl not adjusting your trigger properly) bad solenoids and bad boards. How could it be our fault if we get our Matrices from the same distributor as everyone else?
MATRIX is offline  
Old 05-14-2002, 06:14 PM #3
Team Bio
Team Bio's Avatar
Join Date: Aug 2001
 has been a member for 10 years
Yes "MATRIX" that is very true.the guys @ TMC are very helpful and its NOT there fault that you have problems with your gun. I bought my gun from PBC do I blame them if its WGP's (I bought a cocker) fault. No, and you shouldn't either. TMC is the most helpful people in the US. They may charge a little bit more, but its for quality not cheapness and breakage. your Addvark stuff breaks you send it to them, so stop your complaning.

Sorry Dave
Erick Smith {A.K.A Smith Erick}

Last edited by Team Bio : 05-16-2002 at 06:08 AM.
Team Bio is offline  
Old 05-16-2002, 01:22 AM #4
There is no spoon
marc's Avatar
Join Date: Feb 2002
Location: Ontario, Canada
 has been a member for 10 years
Does TMC put their parts on after they receive the Matrix, or is it put on from the factory at Airtech in quebec?
marc is offline  

Posting Rules
Forum Jump