Man This Sucks! Someone Help!

DeathsGuard · 02-20-2005, 07:02 PM

I was trying to get my 3-way off on my dragunfly mech and one of the barbs snapped off!

I am currently applying apoxy to put it back on, and teflon tape it when im done to make sure there are no leaks.

If i dont like this ghetto set-up should i save for a new 3-way and re-tap the front block? What size is the tap that i need?

DeathsGuard · 02-20-2005, 07:18 PM

PLZ someone help, this is the worst thing to happen to me!! I haven't even used this gun in a game yet, just for testing.

tombstone · 02-20-2005, 07:22 PM

REplace the barb.

GooG · 02-20-2005, 08:06 PM

yea, shouldnt be to expensive

DeathsGuard · 02-20-2005, 08:15 PM

?? I dont even know if i can, the base totally snapped off.

meet_the_focker · 02-20-2005, 08:38 PM

wouldnt of happened if you would have taken the hoses off? & taken the lpr off to make it easier

DeathsGuard · 02-20-2005, 10:37 PM

I did take the hoses and lpr off.
Oh well if i cant apply apoxy, ill just re-tap a hole in the front block so i can use regular 3-ways.

But i have another question, can i use the same hoses on a different 3way that came stock with my dragunfly? or are they too big?

topspot · 02-21-2005, 03:25 AM

u need an extractor kit to remove the broken barb. you can get it at any hardware store

DeathsGuard · 02-21-2005, 09:21 AM

Ok, yeah the base is stuck in the 3way
I guess ill have to use my piranha to play today.

Will any autococker barb fit a dragunfly 3way? Because the hoses are thicker than regular autococker hoses and im not so sure.