So I have a Tac One and I don't like hoppers and longbow mags cost a lot...so I decided I was going to try something.
Someone local was selling a Rap4 P68 pistol with a few mags so I asked him to part one.
This was my Idea.
It looked like it might fit so I started cutting!
A short time later I was done
And it fit! Quite nicely too!
This is what I see from the back.
Then I went to test it...and the macro fitting on the bike grip Blew!
After I changed my pants I experimented with a few different ways to route the air source...and finally I have half settled on what was originally my vision in the first place. I mounted a 3.5oz strait up to the VA...however the burst disk would not clear the trigger frame so I had to use an ASA extension. It works...but it is not exactly ideal, the extension I have is about an inch and a half long and makes the 3.5 hang a bit low...it will do for now until I come up with a better solution.
Tested this out with Reballs...but they didn't want to feed very well. Hoping its just the Reballs...
Still to do:
-Drill a hole in the spring feed for a side feed port!
-Try not to sell the whole dam thing...
-Anno? (After a lot of other bills are paid)
And as a bonus...I discovered enough other spare parts to build a second mag!