Ok, For everyone who has wanted to know how to take apart clean and relube the noid on e-cockers to prevent or fix leaks, here you go. I'll get right to it.
*TOOLS* - for this job you will need:
Small philips screwdriver
1/8th inch allen key for frame screws
1/16th inch allen key for eye cover
5/64th inch allen key for grip screws
Small cloth or towel
Pic 1- Remove eye and cover.
Pic 2- Remove frame.
Pic 3- Remove noid screws.
Pic 4- Take off gasket and get ready to disassemble.
Pic 5- Remove the 2 screws and remove front cover.
Pic 6- Remove the two screws on the back and seperate the pieces.
Pic 7- Remove the next 2 screws and seperate the next two pieces.
Pic 8- Poke out the piston with the screw driver.
Pic 9- Get some dow33.
Pic 10- Lube the piston, reinsert it, and screw the next piece back on.
Pic 11- Screw back on the back piece.
Pic 12- Reattach the front piece.
Pic 13- Clean and relube the gasket.
Pic 14- Screw the noid back in the housing making sure the gasket doesn't move.
Pic 15- Reinstall the frame, all wires, and the eye.
*NOTE* Inbetween all seperate pieces of the noid there are small gaskets, DO NOT loose these. Lube each gasket before reassembling.