First, turn out both set screws all the way and then turn on the air source. Then turn in the set screw on the Torpedo 2.5 times which will allow air to flow freely into the LPR or Horizontal reg. Next turn in the LPR set screw until the pressure on your guage reads 80 psi. Once you've done this, your LPR is set and you'll have to go to a chrono and adjust the Torpedo either in or out to adjust velocity. Keep in mind that the 80psi setting I instructed you to set is NOT set in stone. The actual suggested pressure from the factory is 85 but 80 will reduce kick (if any) a tiny bit, so if when you try adjusting the Torpedo you velocity is inconsistent, try turning up or down your LPR 5psi at a time and see if that stablizes your velocity.
Hope this helps!
- Performance Optimized Weapon Enhancement Research
VICTORY & G6R TRIGGERS AVAILABLE – GET YOURS TODAY!!! – Custom Colors Available!!!
GEN5/MARQ POWER Series Triggers will be run in VERY LIMITED Quantities! – Currently Sold Out but can be run again with 25 Pre-Paid Orders!!!
– BLAST Manual Specialist '05 - '08
– The Yakuza has arrived!
– The best in Paintball Anodizing!