Trigger installation?

Apex · 03-29-2002, 11:45 AM

I just got my wermstick in the mail. I checked the faq to see how to install and adjust it and it says nothing. Can someone help me with putting in my new trigger? How do I take out the pins? etc.

wolverine · 03-29-2002, 12:15 PM

Look again !!!

Here is the link to the instructions on installing aftermarket triggers. http://www.kamworld.net/paintball/Im...grades.html#U5

Apex · 03-29-2002, 01:16 PM

How do I remove the C-clips? They are being a pain.I'm about to pry them off with a flathead.

wolverine · 03-29-2002, 03:14 PM

I have a small pair of needle nose plyers that work great, just grab and pull.

If you use a flat head screwdriver, becareful of 2 things....1) don't slip and scratch your ano. 2) the c-clips will act like springs and go flying to never be seen again if you are not careful

P8ntballingfool · 03-29-2002, 03:47 PM

i ue a small allen wrench on one end and a screwdriver on the other. ALSO remember which order the pins go in

Apex · 03-29-2002, 04:30 PM

Wolverine thanks for telling me but you told me too late! I lost a C-clip. You know where I can grab a replacement? Maybe a hardware store?

Apex · 03-29-2002, 05:27 PM

Yeah I finnaly got it all together on the setting I like - a c-clip. I cant turn it off because if I do It wont go back on. Due to the tight setting I have it on whenever I flip the switch the gun thinks the trigger is being pulled and will stay green. Will leaving it on drain a lot of power? Oh and I dunno what I did to it but whenever I realease the trigger it shoots again. Or If I blow on it it shoots. Is that going to mess up my gun? I can get it going up really damn fast. Now I wish I had my WAS board!