Originally Posted by AlmightyRuler
I had a bad leak out of my bolt a little while ago, too. I also checked the stickies & replaced the stem o-rings as the sticky recommended. Pointless. It ended up being the bolt sail. It looked okay at first glance. But I replaced it anyway. That stopped the leak right away. Replace yours. It may look good upon initial inspection. Just replace it anyway.
Are you sure you're using 100% Buna o-rings? Most are. But the inner tophat & can o-rings are urethane. I had one of those replaced recently as my bolt wasn't sliding back & forth smoothly. I've never personally taken my LPR out. I'd have to check the manual to see what they use & where.
yes i am using 100% buna or rings. thats one of my questions and hopefully my issue is. thats what i ment by ALL BUNA ORINGS. every single one of my orings on the bolt and lpr including the ones that dye says to use the urethane. ill get the urethane ones and try to see if that works, if not then ill try a diffrent bolt.