[captsarcastic69]

I saw the new Cyborg at the MGO and I have a question. I saw the gun taken apart and the lpr looked more like the velocity adjuster on a spyder than like a true LPR. Sitting in front of the cupseal, it just looked like it screwed in and out and had no line out like the solenoid line on an impulse or a cocker. I was thinking about buying one and was curious (not that it will affect my decision).

[Tekk13]

Ummm...It's an LPR...trust me. It regulates the pressure going to the solenoid...so it has to be more then just a "spyder velocity adjuster". I have to admit, the design is fairly simple, and should give very few problems. I have come to expect this trait from Mac Dev. I do have to say I don't like trying to line upp the shaft going from the body to the spring though...pain in the a$$ if you ask me. HAHA...I am sure I will come up with a simpler manner of putting it back together tho...

It's all good.

What was your question again?

[vmhuang]

There is a pressure line running from the lpr to the solenoid.. you can't see it from the outside, ala Intimidator and bushy. Can't get away from this design unless you use 3 tubes like a Viking or an Angel. Then 1 whole tube is lp.

[Tekk13]

HAHA...I totally missed the line comment the first time I read his post.

Musta been sleepin'