I'll apologize in advance for what I'm sure is a noobie question, but I really did try searching before posting.
I recently purchased the TechT L7HE bolt engine for my G3. (Yes, I know about the new g3 bolt kit
that deathwish_dw is working on, but I got a good deal on the L7 and plan on trying out the new bolt kit once it is finally released). The TechT instructions say that after you install the kit, you should lower your pressure to 150-165psi and you should lower your dwell settings. I've also been reading the Dangerous Power G3 guide
and it says that a G3 with a techt engine should have the dwell at 8-10 ms and ABS set to 2-3 ms. However, from the G3 manual
it appears that the lowest the dwell can go is 12ms (which is where it is set currently), and there is no separate setting for ABS. Is that correct? Is upgrading to an aftermarket board the only way to lower the dwell farther and have the ability to adjust ABS separately? Or is there a secret dip switch setting for lower dwell on the stock board?
The reason I ask at all is that if I lower the pressure to 150-165, then I'm shooting in the 240fps or lower range (our field limit is 300). My marker also seem to be a bit of a gas hog, and I had hoped the new bolt engine would fix that.