Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

Reply
 
Thread Tools
Old 07-22-2013, 12:07 PM #1
tim2thousand4
Breakout Action Sports!
 
tim2thousand4's Avatar
 
Join Date: Apr 2002
Location: St. Louis
Annual Supporting Member
 has been a member for 10 years
tim2thousand4 is BST Legit
tim2thousand4 is playing at Living Legends VII
tim2thousand4 owns a Planet Eclipse Ego
tim2thousand4 has achieved Level 1 in PbNation Pursuit
tim2thousand4 supports DLX Technology
Check this BEFORE asking an insight question!

CHECK YOUR INSIGHT'S BOARD FOR BIP SETTINGS. IF YOU DO NOT HAVE BIP SETTINGS ON YOUR BOARD, CONTACT ME OR BLAST FOR A WARRANTY SWAP FOR A BOARD WITH THE LATEST FLASH.

BLAST - HOURS 9-5 PST
(209) 293-4440

For all UPS & FedEx Shipments:
Bob Long Technologies
11669 Highway 26
Mokelumne Hill CA 95245

For all US Postal Shipments:
Bob Long Technologies
PO Box 457
Mokelumne Hill CA 95245

BREAKOUT ACTION SPORTS - HOURS 5-10 CST
OR TEXT ANYTIME
(618) 334-5732
Tim Wolfe
Breakout Action Sports
6209 mid rivers mall drive
mailbox 101
St. Peters, MO 63304

Dropoff Issues

1. Battery Level - Fresh high quality batteries only
2. Engine is properly lubed
3. Engine is tightly screwed together.
4. Dwell is 10-12 MS
5. U-CUP oring is correctly installed
Note: If this is the front of your engine XX, and the U-Cup oring is ( , then the flanged part of your u cup onring should be installed this way: XX(
This should cause a little drag in the rearward stroke, not the forward stroke.


My gun is BOUNCY!

1. Un-install your trigger.
2. Take out your trigger spring.
3. Re-install your trigger
4. Adjust the trigger to have extra length in the pull
5. Make your trigger activate the switch LATE in the pull
6. Turn up your debounce to 10-20ms
7. Turn up your eye delay to 25ms
8. Turn up your BIP delay to 10-30ms

Leaking between the frame and body

1. Oring between the body and frame has been dislodged. Properly realign and lube it, then reinstall the frame.

Eyes aren't reading the paint

1. Check the board version. If it doesn't have the BIP setting, send your board to Blast to swap it out for the new flashed version.
2. Check to make sure your eyes are clean and make sure the eyes are properly connected to the harness.
3. Check to make sure the wiring harness is completely connected to the board.
4. Check your battery level.. Fresh high quality batteries only
5. If all else fails, replace the eyes / wiring harness

I'll add more to this as I go. I just wanted to give you guys a basis to work from.

Last edited by tim2thousand4 : 07-22-2013 at 12:14 PM.
tim2thousand4 is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Advertisement
Reply


Thread Tools

Posting Rules
Forum Jump