Originally Posted by Naumoff42
I just wondered because i just recently acquired a NOx bolt and I've been trying to make the ultimate power core for a quiet shot. I haven't had a chance to test the bolt too much but I've been impressed so far. Hopefully it will work with the ft screw because my ndz can never would. Right now Im using the nox, 2.0 can (ill chop a bar off soon) and a stock bolt guide with two of the bars chopped off to add volume. Once i can find a cheap ndz guide Im going to do the same with that
Your going for the exact same setup as me. I too am wanting the most quiet shot I can achieve. I definitely recommend the 2.0 can over the ndz v1 can. I literally tried 100 oring combinations on the v1 can to get my luxe to cycle with the ft in without a ridiculous dwell or fsdo and had 0 luck. Granted I haven't shot paint yet im getting full healthy cycles at 12ms with the FT installed! FSDO is currently at 1. I imagine ill end up putting the dwell at 14-16 either way as its not that important on the luxe as far as efficiency is concerned but time will tell while tuning over a chrono.
I also have a vented solenoid block however I have a stock spare I will swap as well. I really wish I had a luxe pressure tester to document what parts really lower how much of the operating pressure for the same chrono speeds etc but it appears they stopped producing them
I had my body converted to A/C threading so I can use the Sanchez Orbium III barrel. It should be stoooooopid quiet with the amount of porting on that kit but time will tell! Do share what you find/test please, I will do the same!