[vm68blurp]

Hey I was wandering if the Resurection could be made into an E/cocker?

[Deadmeat99]

you would have to modify the frame slightly, the empire frame is mounted quite differently.

[tacxplosion]

You'd need to drill & tap the body and countersink the frame for one mounting point or use an MQ valve and an ego frame, you'd probably still need to countersink the ego frame though. Eblade frames are too short to cover both frame mounting points on the empire platform.

[vm68blurp]

Thanks.I was going to pre order one but I think ill wait and see if empire comes out with one.

[SilentBall55]

This is the part where Empire should have conformed to the WGP compatibility to use existing grip frames like the WGP hinge and E1/E2 frames.

Just using LPR regs, 4way and rams is not good enough.

The other beef I have is the valve is a Piranha valve not cocker valve specs. I have a spare AKA valve that can't be used.

[barrel roll]

merlin valve spec > wgp valve spec

Eblade frames suck, as well.

[hmcl281]

Originally Posted by barrel roll

merlin valve spec > wgp valve spec

Eblade frames suck, as well.

wgp merlin spec is not the same as a true merlin spec

[barrel roll]

Orly. Please enlighten, more knowledge is always good.

[hmcl281]

Originally Posted by barrel roll

Orly. Please enlighten, more knowledge is always good.

wgp uses wgp spec for the lower tube, to add the merlin spec they drill right up to the spacer that the valve spring sit against. i'm not even sure if they go that deep. no other way for them to do it since they using wgp blanks, if they drill deeper it would cause a hole where the front grips screw hole is.