[Worldofpaintball]

What should I set my ninja tank to (pro reg. on tank).
What output pressure?
450 or 550?

[SHOOTNPOO]

450-550 is just fine. I run SLP so you know the markers can handle it.

[Worldofpaintball]

How do you set operating pressure? The 100psi

[FrmrSpecialist]

Originally Posted by Worldofpaintball

How do you set operating pressure? The 100psi

By adjusting it to proper chrono speeds

[Worldofpaintball]

Ahhh so the only adjustment is the hpr. The gun just operates at 100psi at the 280 +-fps rating

[Paint_hore]

Try searching

[dom088]

Originally Posted by FrmrSpecialist

By adjusting it to proper chrono speeds

^

[Worldofpaintball]

Does it mean anything if your gt has a number of "0010-0020" on the back?

[firefoxx04]

That is your serial number.

If you are not sure what your pressure is, degass the gun. turn the regulator screw (1/8") all the way in (dont crank it down, just turn it in until it wants to stop)

air the gun up, turn it on eyes off (no paint). Slowly bring the reg screw out while pulling the trigger. It should start puffing. Keep turning it out until the gun cycles fully. Once it does, bring it to a crono and adjust to your field speed.

100psi is where the gun should sit with a good paint to bore match once it is broken in. You dont need to worry about it.

[Worldofpaintball]

Do you mean turn in?

[firefoxx04]

turning the screw in lowers pressure, turning it out increases pressure. When in doubt, its best to start at 0psi and work your way up.

once its set, you dont need to worry. Just crono each time you play and adjust as needed. It wont change much week to week.

[Worldofpaintball]

Originally Posted by firefoxx04

That is your serial number.

If you are not sure what your pressure is, degass the gun. turn the regulator screw (1/8") all the way in (dont crank it down, just turn it in until it wants to stop)

air the gun up, turn it on eyes off (no paint). Slowly bring the reg screw out while pulling the trigger. It should start puffing. Keep turning it out until the gun cycles fully. Once it does, bring it to a crono and adjust to your field speed.

100psi is where the gun should sit with a good paint to bore match once it is broken in. You dont need to worry about it.

So it's not like the first 10-20 units in production

[firefoxx04]

I have no idea what you are talking about

[The_Fresh]

this thread is hilarious

[Mark S.]

I'm confused as well. Your GT's serial # will be depicted by 4 numbers. I'm not sure what you mean by "0010-0020"

[The_Fresh]

ladies and gentlemen i present to you...

(drum roll please).........


the macdev clone gt manual!!! please everyone give it a round of applause!

http://www.macdev.net/manuals/CloneGTweb.pdf

[Worldofpaintball]

the manual says nothing about the number stamped.
so its just a serial number.
its not like if mine says 0018 than it was the 18th marker in production

[Mark S.]

The serial numbers do go sequentially in the order the GT's are produced. Is that what you're wondering, or is there something else you're specifically asking?

[Worldofpaintball]

thanks mark!
you have answered my question.