Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

Reply
 
Thread Tools
Old 02-25-2013, 05:23 PM #1
KronicCocker
 
 
KronicCocker's Avatar
 
Join Date: Aug 2002
Location: 508
 has been a member for 10 years
Trigger replacement

Received a trigger in a deal I made for a viking and want to try putting it in. Any walkthroughs on this? I had the frame off, but was curious if I had to remove micro switch to get it out?
KronicCocker is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Advertisement
Old 02-25-2013, 05:28 PM #2
fsrxc1
 
 
fsrxc1's Avatar
 
Join Date: May 2004
Location: mass
 has been a member for 10 years
Not if you pull all the screws in away from the switch, but some triggers work better with the switch flipped...depends on what kind it is
__________________
www.destructivecustoms.com
For all your AKA service and milling needs. Fully Authorized in the repair of Viking, Excalibur, and Merlin Markers.
mark@destructivecustoms.com

Rampage X-Ball
Monster Paintball- I Bleed GREEN
fsrxc1 is offline   Reply With Quote
Old 02-25-2013, 07:32 PM #3
Dark Side
You will know the power
 
Dark Side's Avatar
 
Join Date: Mar 2007
Location: Charleston SC
Annual Supporting Member
Dark Side is BST Trusted
Depending on the frame, it should only be 2 screws or pins holding the switch in place. Either way pull it so it can't be damaged in the process. Then take a nail set and lightly tap the pin out. The whole process should take less than 5 minutes.
__________________
WTB

07/08 Ego Vici Board
Dust Black ShockTech AutoCocker snatch grip
Dark Side is offline   Reply With Quote
Reply


Thread Tools

Posting Rules
Forum Jump