[josefm93]

i have a karnivor and whenever i adjust the lpr it starting to leak at the solenoid. any ideas or same problem.
thanks for the help.

[hmcl281]

to much pressure into the noid

lpr need to be rebuild

the noid need to be reinstalled or 2 screws need to be tighten

[josefm93]

I reinstalled the solenoid and tighten the 2 screw, but still leaks. I will try to rebuild the LPR. Thanks

[hmcl281]

if you have a bad ram it will cause the noid to leak also

simple way to test the ram is to plug the 3way hose from the lpr into one of the barb of the ram and see if it leaks out the other barb

[Rebel_816]

or just unplug the hose from the front of the ram. if air comes out the ram its the shaft o-ring.

lpr too high will cause noid to vent. or solenoid gasket could need replacing if your sure its set in place properly. a very light coat of grease helps. if rebuilding the lpr or the ram shaft isnt it the gasket may need replacing. www.paintballgateway.com has them.

[josefm93]

so i plug the hose from lpr direct to the rear ram and no leak to the front.
only leaks whenever the lpr turn in
i will order a gasket and see from there. if still leaks i might bring it to the shop

[Rebel_816]

Originally Posted by josefm93

only leaks whenever the lpr turn in

turning the lpr in raises the pressure. too high will cause the noid to vent. meaning lpr is set too high. it just needs to be high enough to cock the gun.

[josefm93]

whenever its time that the gun cocks it starts to leak at the noid.

[josefm93]

my karni has been fixed. found that the noid itself is leaking.