[Snetard]

Hey, my quest will only cycle fully for one shot then it stops cycling unless I wait a few seconds. I've tried a bunch of things but I am out of ideas.

I have already...
-Changed o-rings on bolt + guide a few times to see if hand fit would work, didn't do anything.
-Tried 2 different hpr's
-Tried a different solenoid from my dm5 which is working perfectly
-Changed the battery 3 times
-Took out lpr valve core to inspect o-rings, they looked fine but i'm not sure if it could be damaged otherwise (maybe someone has had a similar problem and this was the cause, because i'm not sure what a broken valve core causes )
-Also I am not out of air

~~LPR is at around 100 dwell is at 12

Thanks
Here is a video!

[ironyusa]

My board went out and had similar symptoms.

[Snetard]

Hmm, didn't even think about that.. hopefully thats not the issue D:
Thanks.

[Demo2222]

Bad valve core will cause the lp to creep- don't think it would cause those symptoms.
Have you rebuilt the lpr? Or cleaned and relubed the piston oring. Almost seems like the lp isn't recharging?
Or could be the board. What board is in there? Ape? How are you setting the lp? Do you have a gauge you use to set it then remove the gauge? It might help to have the gauge on while trouble shooting.
Nice raider btw

[Snetard]

Yeah I cleaned/lubed the piston, didn't change the o-ring guess ill try that as well tomorrow. I have a lucky ace board. Yeah I set it to 100 because the only working gauge I have at the moment is old and goes from 0-500 so its kinda hard to see anything. But yeah it seems like it isn't recharging which is why I swapped noids but its doing the same thing with one that i know works.
Thank you :p

[Demo2222]

Is it possible that you need to turn up the lp a little more? Do you know what the output on the hpr is?
If all else fails and you want to send me the board I can test it on a known working platform and let you know if that's the issue

[excope]

I agree with Demo on his last post. Acts like the lp is too low, even on the first shot. May not be the issue but that's where I'd start.

[ironyusa]

Also, not sure if you're aware, but gauges are only accurate towards the middle 25% of their range. A 0-500psi wouldn't be real accurate at 100psi.

[Demo2222]

this- if you decide to buy a gauge get a 0-160. I think I found them on amazon last time I bought a couple. these http://www.amazon.com/Custom-Product...60+micro+gauge

Originally Posted by ironyusa

Also, not sure if you're aware, but gauges are only accurate towards the middle 25% of their range. A 0-500psi wouldn't be real accurate at 100psi.

[Snetard]

Fixed it! thanks for the help everyone. Heard a tiny leak coming from the lpr today which I didn't hear yesterday. It was the size 18 o-ring on the top of the lpr housing.. it looked fine but i guess it was worn out just enough to not work which is why I didn't change it yesterday. Gonna pick up one of those gauges as well if I cant find mine thanks demo :]

[ironyusa]

Glad you got it fixed. I strongly recommend putting a vent hole in the LPR (through the screw or reg body -- Juit modding) if it doesn't have one already.

[Snetard]

It does not, thanks :]