[sean000020]

Hey, Thank you for taking your time and looking at this topic. I hope someone can help me.

My gun is brand new and stops firing after five shots. I'm new to MacDev guns.
It sounds like its getting no air flow even though the tank reads 4500 psi. and A Fresh 9V.

[SHOOTNPOO]

Are the eyes working? Can you turn off eyes and cycle marker?

If non of these work try what ive said below.

Even though new try changing out the two bolt switch orings. Also zero out the reg and open the reg about 1 1/2 -2 turns and try that.

[sean000020]

Originally Posted by SHOOTNPOO

Are the eyes working? Can you turn off eyes and cycle marker?

If non of these work try what ive said below.

Even though new try changing out the two bolt switch orings. Also zero out the reg and open the reg about 1 1/2 -2 turns and try that.

The Eyes do work. But when I'm shooting the gun just quits shooting. I'll try what you told me to do and then I'll tell you what happens.

[sean000020]

I've changed them o-rings and I've done the 1 1/2 turn. Its still sounding like its getting chocked. my reg will not come apart either.

[SHOOTNPOO]

Its choking like its half cycling or when you are at full ramp its sounds as its choking .

If you would like to send it in you can so we can see if its a simple issue or a failure.
Where did you buy it from?

Email customerservice@aggressivesports.net

Thanks
Eric

[KryptonicsPB]

Originally Posted by sean000020

Hey, Thank you for taking your time and looking at this topic. I hope someone can help me.

My gun is brand new and stops firing after five shots. I'm new to MacDev guns.
It sounds like its getting no air flow even though the tank reads 4500 psi. and A Fresh 9V.

Possible your Asa knob isn't screwed in all the way, or that your tank pin might not be compressed enough somehow.

[o5pr3y]

Do you have to restart it to get it shooting again, or just wait a little?

If it starts up after a brief pause, that's starving for air like listed above.

If it needs a restart I'd send it in, as that sounds like a board issue. Setting the board back to factory may help too if you adjusted it.

[sean000020]

I bought it right from macdev. Also the Reg. Will not come apart. I'm scratching it trying to get it off with tools.. So would that void the warranty?

[SHOOTNPOO]

Scratcing it wont void unless the scratches are the cause inside the boar but I dought that its the issue.
Please visit
Www.aggressivesports.net
Click warranty form, fill it out and send in with copy of proof of purchase receipt.

[The_Fresh]

is your hopper on lol

[sean000020]

lol, Yes my hopper is on. It even does it when I shut the eyes off and shoot it.