[Sottyman]

So I just mauled a pair of grips trying to make them work on a KAPP frame. Are there any decent grips that works with this frame or am I stuck making panels out of regular grips?

[Nobody609]

what grips did you "maul"? what are you trying to do? i'm sure if you could look for a pair of Dye LCD stickies.

[Sottyman]

Those are the kind I ended up having to cut into panel grips. Only problem with that is the 1 grip screw on the bottom- it allows the front lower portion to flex, basically leaving some nice gaps for dirt/paint/water/etc to freely find its way to the board.

[dr.strangelove]

What's the problem with the grips you're using? Is the finger grip portion on the front too tight or something?

Do you have access to any stock grips? Perhaps the Dye ones were just a hair off from the stock hole alignment?

[Vegard]

Isn't he thinking of the fingergrooves on the frame and not the screwplacement?

Making panels or buying spd grips is your best bet, never seen suitable panelgrips for these frames.

[dr.strangelove]

Ahh, yeah, you're right. I wasn't thinking of those grooves in the frame.

Yeah, panels would probably be your best bet.

[sledneckforlife]

I end up cutting my own when guns come without them. 1/4 lexan and some countersunk holes, lil bevel on the edge....booyah