Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

Reply
 
Thread Tools
Old 02-10-2013, 11:41 PM #1
shane_lxi
Doooooooooork
 
shane_lxi's Avatar
 
Join Date: Jan 2013
Location: Hoquiam, WA
Halo B will not change speed

Just bought a used Halo B. Never had one before, so I looked up an owners manual online to find out how to change the rotor speed. No matter how long I hold down the power button, nothing happens. The manual says it should start blinking and each initial press after that will change the settings.

Also, the led is blinking red (not alternating red/green like its broken), but I figured this is probably because there is no paint in the hopper?
shane_lxi is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Advertisement
Old 02-11-2013, 12:01 AM #2
pynis
Reagan owns my soul
 
pynis's Avatar
 
Join Date: Aug 2005
Location: beware the PHOG
pynis plays in the APPA D5 division
pynis is one of the top 250 posters on PbNation
pynis is Boss
Which board do you have and which board manual are you looking up?

I would say its blinking red because of low batteries. Try replacing them
__________________
Paintball24Seven is immature, a troll, and his pawnshop prices are laughable. Avoid business at all costs

"Originally posted by a_nxiety: screw ego's, everyone in the world shoots one. might as well sell them at hollister next to the pre-stained white hoodies and the jeans where knee's cost extra."
pynis is offline   Reply With Quote
Old 02-11-2013, 12:31 AM #3
shane_lxi
Doooooooooork
 
shane_lxi's Avatar
 
Join Date: Jan 2013
Location: Hoquiam, WA
I'm not sure how to tell which board is in it. This is actually that red one I just got from you pynis, lol. (don't worry, I'm happy with it and I'm sure there's something simple going on here)

This is the manual I was looking at:
http://www.paintballsolutions.com/pd...v35_manual.pdf

I'll try new batteries tomorrow, I just put new batteries in it, but I have been messing with it a bit since then. I took it apart, all the wires look ok. I'll replace the batteries, if that doesn't work I might try replacing the motor.

Last edited by shane_lxi : 02-11-2013 at 12:37 AM.
shane_lxi is offline   Reply With Quote
Old 02-11-2013, 12:36 AM #4
shane_lxi
Doooooooooork
 
shane_lxi's Avatar
 
Join Date: Jan 2013
Location: Hoquiam, WA
Edit: just realized on the PDF it says only the v35 is adjustable, lol. So I'm sure the redlight blinking thing is something simple.
shane_lxi is offline   Reply With Quote
Reply


Thread Tools

Posting Rules
Forum Jump