I can drill and tap trigger frames to accept set screws to lock in trigger bearings for an unbeatably smooth pull with zero side-to-side play, like how the Luxe trigger frame is designed. This is a huge improvement over guns that just use a pin as the trigger's pivot point. It also makes the trigger easy to remove instead of having to hammer out a pin every time.
This mod also takes full advantage of triggers with dual ball-bearings and works best with them.
I will drill and tap both sides of the frame for 8-32 threads and install the trigger with a pair of either 1/8" or 1/4" set screws, depending on the width of the frame.
I'm offering this service for $30 + return shipping for guns with flat frames (Axe, some Shocker frames, Ion, Clone, Droid, etc). Guns with milled sides (Dye, PE, etc) are more difficult and prices vary.
Feel free to post or PM questions and comments.