Hey all, have some technical questions and hope I can get an answer. I am in the process of making my own marker using some existing parts I had laying around. I am going for a bullpup style (regulator behind gripframe) and have a some questions regarding how-to.
Just a little eye candy:
Here a message I recently sent to Custom Products because I thought about using their ASA and regulator for the marker; I'll quote it here in hopes of getting some answer, I know this forum has a lot of knowledge.
To whom it may concern:
I am a non-incorporated engineer/machinist that is in the process of building my own paintball marker and am considering using your products for it. I have several questions regarding several of your parts that I would like to adapt to this marker and would appreciate it if you could answer them. If you could forward this to the right person (I'm assuming this is the sales department) I would really appreciate it. Here is what I got:
1) CP Gen 3 Inline Regulator
1a) What psi range is this designed to work at and how to adjust?
1b) Where is the psi adjuster (bottom/side) and where is the macro line fitting located (bottom/side)?
1c) What is the overall length?
1d) What type of male threads are being used for this (listed in ASTM F1750-05)?
2) 2000k-5000k PSI On/Off ASA
2a) Is there macroline fittings located on both sides (the photo shown looks as if there is only a hole on the viewing side)?
Answers to these questions would be greatly appreciated.
If anyone can help it would be greatly appreciated.