Or raising pressure. The value needs even pressure to seal you have to much or to little assuming all your orings are good.
This has been a TEST, This life has been a TEST.
Had this been an Actual LIFE you would had lived in
the Mountains, Never worked and SKIED EVERY DAY
I can say for certain that if you have a working cocker that shoots just fine you are one of the three, or all of the above. 1- you are not an idiot. 2- you know someone who is not an idiot. 3- you have enough money to pay someone who is not an idiot. - jonotwist
Sounds like a urethane-dot leak to me.. if it's coming from the pilot-assembly itself? Not much there that can leak except for the urethane-dot, and actual poppet + valve-body. And seing as the leak doesn't go down the barrel, I automatically suspect.
Is the urethane-dot new?
Try adjusting your pressures.. If the pressure is too low, it can leak. If it's too high it will leak.
I got it together. before I change the dot i'm going to shoot at tleast a case through it i've been told it should correct itself by cutting a new groove in it
anyways thanks for the tips. heres a shooting vid