[MachineGunCrew]

Go to the Tadao site to check what version your board is so you can check settings.

[imOGpb]

the internals had alsorts of caked on old grease so i cleaned everything up and lightly greased it

[MachineGunCrew]

yeah. I'd break it down and clean everything. check all your board settings and service the reg. start from scratch.

[jim4130]

Originally Posted by imOGpb

just bought it dont know when it was serviced and it has a cp reg

Originally Posted by imOGpb

and do not know exactly what the settingf are at this point i havent adjusted anything yet . it has the dynasty board in it if that helps at all. what might be the ideal dwell settings for the gun. and what the best input pressure for a shocker

Well start with the reg break it down and clean regrease it.
there is no ideal dwell for a spool valve marker due to oring tollerances they're all different. Start at 8ms and shoot then up your dwell until your getting full cycles then give it 2 more ms and your good.

[imOGpb]

thanks alot for the advice guys . will put plan into the action now

[jim4130]

Try a new battery aswell.

[imOGpb]

will do

[jim4130]

And another common cause for shootdown is if the asa is depressing the tanks pin valve to much starving it of air. So you could try unscrewing your tank or your asa knob 1/4 turn.

[imOGpb]

its got an on off so could i get the same effect by backing off with the valve actuator

[jim4130]

Thats what I meant by asa knob so yes unless its the stock smartparts ASA because that one doesn't have a pin that moves via the knob.

[imOGpb]

oh hah kinda drunk didnt even see the asa knob part

[perez62682]

how many stoned assassins shockers were made?

[K-9]

Somewhere around 10-20

[ikill4sp]

My shocker leaks as soon as I air it up. I turned the regulator screw all the way in and it doesn't leak. As soon as I unscrew the regulator screw a little bit it begins to leak. Any ideas?

[MachineGunCrew]

location of the leak? down the barrel? through the frame?

[perez62682]

Originally Posted by K-9

Somewhere around 10-20

thanks appreciate it

[ikill4sp]

Originally Posted by MachineGunCrew

location of the leak? down the barrel? through the frame?

It leaks out of the top/rightside of the noid I believe.

I checked the bolt o-rings that zdspb said to. Also, I checked the manifold o-rings, all of which look good.

[ka-titties]

put a thin, almost invisible film of shocker lube or similar over both sides of the manifold and make sure the noid is sufficiently snugged down. if the lube helps, i'd replace the manifold o-rings.

[ikill4sp]

I bought my Shocker and the eyes weren't working. I just replaced them and cleaned my gun and the vision still doesn't work. Could it be possible that a damaged wire harness is the cause of this issue?

[jim4130]

It could but it could also be a number of other things. What board are you using and what are the eye settings? And is it nxt or sft?

[ikill4sp]

Blackheart. SFT. Haven't checked the eye settings.