VERY troubled day with my '05 Black Magic.
Long story short:
'05 Black Magic with E2 1.10. Has (what I believe to be at least) a KAPP Ram. Also, has a WGP Tickler LPR & an older CP ON/OFF. Everything else is stock.
So, I start the day at SC at the small graveyard field with my dad & three friends. I'm in PSP mode. As soon as it gets into ramping, I realize that balls are starting to break out of the barrel. I get shot out & after the game we head back to the car. I'm checking inside my feedneck & there's a couple breaks in there. Also, there are breaks inside my Rotor.
I'm not sure if the breaks are from these things:
The Rotor. I don't understand why the Rotor would break the balls I had. It wasn't cold by any stretch so they couldn't have been brittle. They were RPS Premiums that sat for almost a week inside of Paintball Gateway.
Barrel: I was using my Kaner kit, but didn't underbore too much. I was actually at .684 in the beginning & thought my barrel was causing it. Switched to a .687 & it kept happening.
Black Magic: It may have been blowback from the gun that caused breaks, but I couldn't imagine that because I just had it somewhat teched by Jerry at I&I here in Carson. Could it be a timing issue?
Any suggestions, Nation?
Last edited by rsion4191 : 01-22-2013 at 07:18 PM.