[Xdanisx]

Ok so I bought an NT10 on here a little while back. I finally got a chance to air it up and there are many leaks. Fortunately, I believe they are all macroline related.

Now there are 3 leaks:

1: Around the macroline near the L fitting. I believe this is just becuase the macroline is kinda stressing the L fitting, see below.

2: Where the macroline connects to the airport. I believe it's the same issue as leak 1, see below.

3: The blead port on the bottom of the new airport asa. With research, it looks like this problem is either do to: bad airport orings, bad reg orings (I'm using my buddy's ninja reg), and I'm not sure if the macroline goes all the way back into the airport as far as possible. not sure though.

Also, someone mentioned that you need to move the airport back. Not sure what he meant by this, if someone could explain this please, that would be nice.



Any help is greatly apreciated.

EDIT: The 45 degree swivel fixed the macroline leakes. The only leak now is the airport leak.

[Paint_hore]

1. Macro could be cut too short causing that stress.
2. Probably the same issue or a dirty fitting.
3. Its the reg oring or an oring inside the asa. Check the manual.

[Xdanisx]

Originally Posted by Paint_hore

1. Macro could be cut too short causing that stress.
2. Probably the same issue or a dirty fitting.
3. Its the reg oring or an oring inside the asa. Check the manual.

Thank you very much. Hopefully the macroline and orings I ordered will solve the issues.