Find fields & stores near you!
Find fields and stores
PbNation News
PbNation News
Community Focus
Community Focus

Thread Tools
Old 01-20-2013, 05:12 PM #1
FCMEDIC's Avatar
Join Date: May 2010
Location: Franklin County, VA
FCMEDIC owns a Planet Eclipse Etek
FCMEDIC has achieved Level 1 in PbNation Pursuit
pipe question

I picked up two brass eagle talons jus to mess around with during the off season. I want to mod them for constant air feed. I picked up two 1/8npt 6" long galvanized pipe nipples. I am just kind of worried about the pressure rating. According to what I looked up online for the pipe nipples they are rated at 150psi WOG @ 150F. Not exactly sure what WOG stands for. What I plan on doing is removing the puncture pin from the valve body, drill out the puncture pin hole to thread in a 1/8npt. Drill out the center of the black knob that you would tighten to puncture a 12gram co2 so the nipples I have fit through nice and snug. I have a dead on asa that I am going to use just need to pick up another cheap asa for the other marker. Am i over worrying, I've seen this method done in several photos of talon mods.
Looking for two players in the 540 area click the link for further details
FCMEDIC is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Old 01-21-2013, 12:11 AM #2
fistfull o'sunshine & joy
jonotwist's Avatar
Join Date: Sep 2006
Location: NE ohio
Annual Supporting Member
jonotwist is playing at Living Legends VIII
jonotwist plays in the APPA D5 division
jonotwist is one of the top 500 posters on PbNation
jonotwist supports Empire
be careful,
jonotwist is offline   Reply With Quote

Thread Tools

Posting Rules
Forum Jump