Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

Reply
 
Thread Tools
Old 05-22-2014, 02:37 PM #1
mikeyr4444
 
 
mikeyr4444's Avatar
 
Join Date: Oct 2011
Location: 570
Annual Supporting Member
mikeyr4444 is playing at Living Legends VII
mikeyr4444 has achieved Level 3 in PbNation Pursuit
I can taste it!

So my builds done minus the tuning. Have it to where I can air the gun up, leak free, and fire the first shot.

The problem is the gun doesn't recock. Tried a heavy and light hammer spring. Adjusted the lug to where it's barely catching up to a few turns in. Solenoid was pulled from a working gun problem free, then also cleaned, and the manual button cycles the bolt. IVG turned up and down a good bit. Lpr adjusted from low to high, right now it's set where there should be plenty of force to move the backblock. But it doesn't move. Doesn't try to cock. Both noids are in the right spots and both connections work (plugged the pancake in both to verify).

I can't hear, accidentally let a shot off while listening down the breech.

Board is Yakuza if that makes any difference.

Thanks, Mike
mikeyr4444 is online now   Reply With Quote
Old Sponsored Links Remove Advertisement
Advertisement
Old 05-23-2014, 07:47 AM #2
Darkapollo
 
 
Darkapollo's Avatar
 
Join Date: Sep 2007
Location: New Cumberland, PA
Post your timing settings.
__________________
Darkapollo is offline   Reply With Quote
Old 05-23-2014, 09:39 PM #3
mikeyr4444
 
 
mikeyr4444's Avatar
 
Join Date: Oct 2011
Location: 570
Annual Supporting Member
mikeyr4444 is playing at Living Legends VII
mikeyr4444 has achieved Level 3 in PbNation Pursuit
For future reference, make sure that the negative lead from the solenoid has continuity. It will manual cycle but not cock otherwise. My friend must have pinched it, was removing the frame to switch to a lighter sear spring and noticed it was pretty flat, removed the heat shrink, and dice, wire was separated.
mikeyr4444 is online now   Reply With Quote
Old 05-24-2014, 08:59 AM #4
Darkapollo
 
 
Darkapollo's Avatar
 
Join Date: Sep 2007
Location: New Cumberland, PA
The manual button does nothing electrically. All it does is force the plunger to vent. Great for unsticking the spool, but not much else.
Pinched and broken wires are quite common on the eblades.
__________________
Darkapollo is offline   Reply With Quote
Old 05-28-2014, 12:43 PM #5
Ademsoar
 
 
Join Date: May 2014
Thanks!
Ademsoar is offline   Reply With Quote
Reply


Thread Tools

Posting Rules
Forum Jump