[hiphophippo8]

I have a azodin kaos pump and I just bought a dye hyper 2 regulator for it. I read online that it might not be high enough pressure for the kaos. I just wanted to know if that was true or if it would be ok on there?

[hiphophippo8]

come on guys 40 views and nothing somebody has to know about this.

[ttimberlak443]

It all depends on which Kaos Pump you have. The older ones didn't have a regulator, so they had a MUCH higher operating pressure. If you have a newer one with a regulator, then it should work fine.

Based on this thread, the older ones operate somewhere between 700-900 psi. That is clearly a pressure too high for the Hyper 2. The Hyper 2 is adjustable between 50-450 psi.

According to that thread, the KP+ operates at 300 psi. That was the regulated KP at the time, so I would assume that the operating pressure of the current KP and KP+ are the same.

So it would seem that if you have a KP with a regulator it should be fine, but if you don't, then you're out of luck.

[hiphophippo8]

Dang I have a old one I bought it with a aftermarket regulator already on it. It was when they first started coming out so I'm sure it's the old one. I have played with it before a long time ago and it seemed to shoot fine but it was a few years ago. I'm going to try it anyway and find out. Thanks for the help.