[codywynn26]

ok so i get my autotrigger and pump kit put on my 04 prostock autococker i initially got the pumnp kit on no problem and i had a pump autococker it worked right then i put the autotrigger kit on after i figured out why i couldnt get it on before and the gun holds air but when i got to pump and shoot i dont get anything?

[HeatedNubbycake]

uh. adjust the A/T cam. the point of the autotrigger is to not let the gun shoot if the pump handle isnt the whole way forward. that only works if the A/T cam is adjusted right. when you put it in hold the trigger in with the trigger against the flat part of the cam, loosen the A/T arm and move it to the hole drilled on the pump arm, tighten everything up and you should be pretty close to where it will be most efficient.

[codywynn26]

i mean like the bolt pin thingy under the bolt the thing you cock back it doesnt stay back unless i pump the gun really slow like just pulling it back and letting it go it will slip forward

[Castro #66]

You need to adjust your hammer lug, accessible through the hole in the top of the body. If you check the Ultimate Sticky at the top of this forum, there are links to installing and adjusting your auto-trigger.