I'd like to start by saying that I've read through the stickys and ZDS and there's no troubleshooting for my issue.
The setup is a Shocktech SFT, Sprung HE bolt, Virtue board.
Slight leak before I took it apart. Before I disassembled it the first shot(eyes off) when you turned the board on would be a full cycle. The next shot wouldn't be a full cycle. If you turned the board off and then back on again the first would be a full cycle, the rest would be weaker. I also know it wasn't reg recharge rate because I waited awhile between a few of the shots and it didn't help.
After I cleaned and relubed with Dow33 the leak stopped. I reset the board back to factory and put in a fresh Energizer battery. The issue is still there.
I'm not sure what else to try. Unless I'm totally missing something obvious, I'm stuck. Help me out Nation