Find fields & stores near you!
Find fields and stores
PbNation News
PbNation News
Community Focus
Community Focus

Thread Tools
Old 12-21-2012, 01:29 AM #1
ewok11's Avatar
Join Date: May 2012
Location: Heflin, Al
ewok11 owns a Planet Eclipse Geo
ewok11 is for the Gunfight
ewok11 has achieved Level 2 in PbNation Pursuit
2 g6r problems

#1. Pressures set to 75/165. Dwell 6, Lp poppet, techt bolt.
Insane first shot drop. After first shot, shooting around 295. Nearly every single time I don't shoot for thirty seconds the first shot the bolt won't cycle completely barely pushing a ball through the barrel. Next shot fires. Chopped ball in barrel. Any solutions? Any one experience the same thing?

#2. (Different gun) Pressure card says 75/175. Set it that and gun won't cycle. It won't fully cycle till lpr is around 120. I know this is way too high. What could cause this? Why won't it work at stock pressures?
Thanks for the help in advance
ewok11 is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Old 12-21-2012, 01:45 AM #2
G00DFELLA's Avatar
Join Date: Jan 2004
 has been a member for 10 years
G00DFELLA plays in the PSP
 plays in the NXL
G00DFELLA plays in the APPA D2 division
Could be an issue with your pressure tester or tank....also gun 1 sounds like the reg isn't recharging properly, clean it.

Gearbag Sale!

Marker Sale
G00DFELLA is offline   Reply With Quote
Old 12-21-2012, 01:50 AM #3
Read the manual!!
gamer565's Avatar
Join Date: Dec 2005
Location: OK
 has been a member for 10 years
gamer565 is playing at Living Legends VI
gamer565 is playing at Living Legends VII
gamer565 is one of the top 100 posters on PbNation
gamer565 is Boss
gamer565 supports Ninja Paintball
#1: Replace the rear ram oring and be sure to use the correct lube, and maintain the regs.

#2: Make sure the dwell is at 6ms, replace the ram orings and be sure to use the correct lube.

If you have not, replace your gauges with better accurate ones.
gamer565 is offline   Reply With Quote

Thread Tools

Posting Rules
Forum Jump