[Dev.]

I can't find this information anywhere, does anyone have the dimensions for the triggers used in the evolve 90* frames? Any CAD files by any chance? I understand that you can't use a standard matrix frame and this is why I'm asking.

[ventturei26]

hm im currently selling a whole frame. i could take it tomorrow and look at the trigger. see what i can get out of it while still in the frame. but it is a special trigger for the evolve frames and there were 2 different ones that they could have come with as well. a flat trigger or one with the finger curves too. ill see if i can get to that frame tomorrow sometime

[Dev.]

Alright thanks a lot man, I appreciate it. Also, do the triggers have bearings? Or is there just a hole milled into them where they pivot on a pin.

[ventturei26]

sorry man i completely forgot about this. pm me to remind me tomorrow.

and no bearing. just a pin to hold it in.