Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

Reply
 
Thread Tools
Old 11-27-2012, 11:06 PM #1
FXpaintball3r
 
 
Join Date: May 2012
DP Off-set detent placements in the Fusion FX??

So I just order the new offset detents for my Fusion FX. Was just curious on which way the detents go in? Does the piece that stick out that stop the ball be facing towards the front (barrel position), facing the top (feed neck position), facing the back (rear end of the gun), or the bottom position towards the handle grip? or does it not matter which way it goes in? Has anyone done this and if so where did you get the information from since this is something that DP just introduce.
FXpaintball3r is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Advertisement
Old 11-28-2012, 12:22 PM #2
FXpaintball3r
 
 
Join Date: May 2012
NVM found out the which way the detents is suppose to be facing in the slot. Was told the little prong should be facing the back of the gun so the dot should be more towards the back in case anyone wants to know
FXpaintball3r is offline   Reply With Quote
Reply


Thread Tools

Posting Rules
Forum Jump