went to air up for first time and got some leaking problems. First a leak out the hyper 3. Tried adjusting the amount being pushed into the gun and no luck. Still leaks. Second leak is at the rear banjo. It's like its putting to much air into it and making it slide out the fitting or push air out of the sides. The third leak is out the barrel around the bolt. The air will push the bolt forward but not back, I have to push the bolt back with my finger each time to get some kind of result.
Sounds like theres a bad o-ring in the hyper 3 somewhere, just look up a hyper3 reg video on how to take it apart and just rebuild it. As for your banjo fitting, it may be cracked. I'll bet someone over-tightened it. You should replace the banjo fitting. And the bolt sticking in the forward position may be a bad bolt sail o-ring, so just replace that o-ring.
check both of the reach orings & make sure the oring on the back cap of the shocktech body is not damaged. I had to replace the stock oring with an oversized oring to get it to seal properly.
