TECHT iFIT Barrel Adapter Phantom to Autococker Barrel Thread
I saw this on ebay and thought it might save me some money in the long run. My question is do these work with any undercocking system? Also how does it look cosmetically? I can't seem to find any pics on google.
Yes, it should work with any undercocking kit. The Python/iFit system adds about 2" to the length of your barrel. Personally if I were you, I'd send the barrel to be bored to accept Freak inserts and then pick up a .675, .679 and a .682 insert. Super_Stanchy on here does Freak boring if you decide to go that route.
"Originally posted by painthappy: I actually LOL'd at this... I don't normally LOL when I type LOL, but this time I mean it."
"Originally posted by BigOldSkool: I've played pump against the worst of the paintball scum bags, do I hang it up? Nah.... I play angrier."
Cosmetically it will add an inch and a half of black space between your gun and your barrel. If your gun is black you barely notice it. If your gun is a different color then you will see the black. But black usually matches everything and doesn't often stick out too bad
The kit is effective at stopping roll outs but doesn't have a long enough control bore to really do much more than that. Boring your barrel for freaks as mentioned above is a better solution.
Ooh. i was in the same boat as you. I kept looking at the tect t ifit kit and the freak kit. For the same price you can buy a a/c freak kit that will be more effective then the ifit. Just have your phantom barrel bored and it will stop roll outs.
Kits on here are like 60 to 90 bucks for a full kit.