[kubish97]

I have a Smart parts ion with a Hybrid on and off push button Asa. I need help to figure out why its leaking air and how i can fix it. It only leaks air when I open the asa. It a little leak coming from the hole in the button. I will post a picture. And if i need to place o orings what size are they and where can i get them.

[Professional Rookie]

Unscrew the button and check the orings. They may need to be replaced or at least relubed. You'll need 2 allens to remove the button.

[MU WISCOBALLER]

isnt it supposed to vent when you open it? When it is closed, it should hold pressure

[Professional Rookie]

No. It doesn't just sit and vent out the tank pressure when you turn it off. It should hold pressure when it is on. If it isn't, you probably have bad orings. I just finished replacing the o's in one of the ones I have. There are 3 10/90 orings in it. You'll need 2 3/16" allens. when putting the screw side of the button on DO NOT OVER TIGHTEN IT!

[Professional Rookie]

I made a video. I'll post it here when it uploads.

[Rebel_816]

those hybrid push buttons were known for being hard on o-rings, so its most likely the cause. pro-rookies vid should show you just what you need to do to fix it.

[kubish97]

Originally Posted by Professional Rookie

I made a video. I'll post it here when it uploads.

Thank u for ur help but i opened it up relubed the bolt but i cant see any o rings in there. I need ur video cause i have no idea how to fix it. And its holding air when i close it kinda. but once i open it ther e is air coming out the buttons for each side.

[Rebel_816]

did you relube the bolt in your gun or the o-rings in the asa?

[kubish97]

Originally Posted by Rebel_816

did you relube the bolt in your gun or the o-rings in the asa?

I cant find the O rings in there. When i took out the button which i called the bolt. the space is hollow and just holes in it. I put greased on the button and slid it through the asa and screwed in the other button on the other side. I tested it out and air still comes out the side when i open it. and its starting to come out when its closed. I need that video so i can fix it.

[Professional Rookie]

[Professional Rookie]

Sorry so late. YouTube was being disagreeable with me.

[Professional Rookie]

Dude. WTF, YouTube? Bear with me. THe video isn't working for some reason.

[Professional Rookie]

Click "Watch in YouTube."

[kubish97]

I wasnt rushing u or anything. I was just telling them what was going on. Thank you so much for the video. I did as u did and lubed the o rings and the inside. I put it back together only to find out it lets all the air out when i close it. I will get new o rings tomorrow and report back. Thank you for making the video.

[Professional Rookie]

Oh, I know I wasn't rushed. You're welcome. It just so happened that I had to fix one I had after I responded to your post. So it all works out! I hope others see the video and can be helped by it.