[willworkforpaint]

Hello everyone, I have been contemplating half blocking my trilogy pump marker. I am currently going to school at NHTI for a CnC Machining coming up on the second semester I now have access to all the tools needed to do it right. While looking for the parts to make a half block I have run into some issues. I was wondering if http://paintballgateway.com/wgp05blmakam.html this cocking sled would work like the WWA kits? If not does anyone know where I could get blue print dimensions to make my own?

Thank you for any insight. It would be much appreciated.

[Darkapollo]

That is a midblock sled, no it wont 'work'.
The midblock sled is thinner then a halfblock sled because you are taking out the space for the top tube. That little gap will cause all kinds of weird problems. The bolt wont be supported through the cycle is the main issue.