[jessekeels]

i have an older ANS GX-3 'chaos series' autococker. the feedneck does not fit any of my hoppers and i was wondering if there is a way to remove it without permenantly changing anything on it. i have tried to twist it off and it does not want to go, but it appears to have threads. does anyone have any experience with these bodies and could lend some advice? thanks

[addicted2dunes]

I don't believe the GX-3's are threaded. You can either replace the feedneck with a threaded one or you can do this: http://paintballgateway.com/trtrautleclf.html

[jessekeels]

Thanks! I didn't realize that is what those were i'll have to pick one up.

[jessekeels]

Bought the trinity feed neck It will not fit the gx-3 stock feedneck I think I'm going to sand down an old revvy as a remedy but if there are any gx-3 owners please don't make the same mistake i did lol

[Darkapollo]

The feedneck is not threaded. Either cut it down for the ego mod or use it as is..

[jessekeels]

Yeah I'm aware that it is not threaded. But the bevel on the top of the feedneck is too big to fit the adjustable trinity adapter on to. Bummer :/

[tacxplosion]

http://www.paintballforum.com/autoco...-feedneck.html

[junk677]

I'm having the same problem with my 2k3

Is it better to just replace it or just get something similar to that piece.

[addicted2dunes]

Originally Posted by jessekeels

Bought the trinity feed neck It will not fit the gx-3 stock feedneck I think I'm going to sand down an old revvy as a remedy but if there are any gx-3 owners please don't make the same mistake i did lol

That's odd..... I had one on our purple GX-3

[jessekeels]

Originally Posted by tacxplosion

http://www.paintballforum.com/autoco...-feedneck.html

This is a great link! Thanks ill have to try that