[demented pumper]

i looked in the stickes and couldnt find what i was looking for.

what is the lpr supposed to be set at?
what pressure does the hpr need to be set at?

gun is only getting half shots. regs have been lubed rammer oiled. can anyone think of any other reasons why its only getting half shots?

[STRIP3S]

Set the hpr pressure to between 300 and 350 psi. I do not usually manipulate much with the lpr. This is for finer adjustments to tune the marker. Also check the dwell and maybe bump it up a little bit. Also, if you have not, check out the PE Manual. Posted a link below.

http://files.planeteclipseb2b.com/ma...-MANUAL-EN.pdf