[Parker(TPA)]

i own a vexor gameface as my back up primary and i was wondering it i could do anything to the trigger to make it better say like and e trigger or just shoot better in general

[kebone]

There's not much out there in terms of upgrades for the Vexor. I do not think a Spyder E Frame will work on them. Game Face made a model called the Vexor Eye which was the same gun with an electonic grip, but they're pretty rare.

Basically you're limited to barrels and regs/expansionchambers. but they're solid shooters as is.

[The Inflicted]

Originally Posted by kebone

I do not think a Spyder E Frame will work on them.

Has anyone tried? Usually these Taiwanese Spyder clones have pretty wide compatibility.

Originally Posted by Parker(TPA)

i own a vexor gameface as my back up primary and i was wondering it i could do anything to the trigger to make it better say like and e trigger or just shoot better in general

I haven't taken apart a Vexor gripframe, but assuming it's anything like the other Spyder clone gripframes I've worked with, the two easiest ways to improve it would be to install forward and rear trigger stops to take out the slop in the trigger pull. The rearward stop is easiest- a small piece of macroline or plastic tube cut to just the right length and placed inside the trigger spring will stop the trigger from traveling past the release point. There are a couple different ways to do the forward stop, but the cheapest I found was to locate the point on the bottom of the body directly beneath the front of the trigger and to scotch tape a small nut or washer there so that it contacts the tip of the trigger and pushes it down slightly, close to the point where the sear engages. A more involved method for either mod would be to thread the frame and/or body for adjustable trigger stops.

http://www.mcarterbrown.com/forums/d...gger-pull.html
http://www.angelfire.com/games/fleshnbonz/indexM.html
http://www.pbreview.com/forums/showthread.php?t=1017