Marq Freakin Out! Yikes
I have a Lurker Spring installed on my Marq. I just got my marq back from BLAST, they replaced the HP Schrader valve in the reg and also replaced the noid. I'm not sure what they set my pressures at because they forgot to return my pressure tester (when the schrader valve went, it over pressured the lp side and blew the gauge). I had the Marq on PSP3/12.5 and it shot well for a bit, but then it malfunctioned by sending balls out at over 40bps without any trigger pull, the hp side though was VERY low, the balls were only flying 30 feet or so. Really a crazy sight...the balls were only a few inches apart, so even though the balls were only flying 30 feet or so, there were 30 to 40 balls in the air. What I think was happening was that the bolt did not have enough return pressure to fully recock and was short cycling. Do you think I am correct? Should I wait on my pressure tester and check the pressures and reset them or should I contact Blast?
MY MARKERS, 05 EGO, MacDev Clone, PM6, 2 Luxes, Shocker SFT, EGO 11, E1, and a few other custom markers
Last edited by tcom022 : 10-29-2012 at 10:49 AM.