[eelpout]

I just pulled out my 1st generation Rail to chronograph it. While I was adjusting the pressure and it started to leak on the body right above the regulator. I had gassed it up and changed the settings the night beofre and it was working fine. This gun was sent back to DYE last Spring to fix the same problem. I was wondering if I could get some ideas what could be wrong with this gun. I already looked at the manual and I am about to take it apart myself.

Thanks in advance,
Jim

[Syphorus]

leaking above the reg as in in the breech? If it's in the Breech change all orings in the bolt drive.

If it's between the trigger frame and body then take it apart and replace the hoses.

[ToBeUsedToBE]

if we are talking about the pmr07 then i believe it has no hoses...? usually when a reg starts leaking while adjusting it is because an oring inside the reg was weak and when turned breaks. check all your orings in the reg if it coming from between the frame and the reg, although really just the one you see when you unscrew it would be the only probable culprit.

[Punisher068]

After replacing all your orings if problem persists check my thread here
http://www.pbnation.com/showthread.php?t=3829014
I used bubble solution to check where leeks are on my guns,you can get a huge bottle at most dollars stores