Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

ReplyRegional Ups
 
Thread Tools
Old 09-23-2012, 12:24 AM #1
greatsoccerman
 
 
Join Date: Aug 2012
led angel help

I know this isn't the gun fourm but I need to find someone in Arkansas that is good with 200-2001 led angels. The gun needed a new battery put one in and the charger light turns green like it is charging, but the gun will not turn on. If someone is close to conway I wouldn't mind driving so you could look at it.
greatsoccerman is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Advertisement
Old 09-23-2012, 08:40 AM #2
dodgeballers_ia
 
 
dodgeballers_ia's Avatar
 
Join Date: May 2006
Location: IOWA
dodgeballers_ia is BST Legit
dodgeballers_ia supports Team VICIOUS
dodgeballers_ia supports Team VICIOUS
dodgeballers_ia supports Team VICIOUS
If you don't have a manual, here's a link to one on my web site. It tell you how to charge it. http://angel-verse.webs.com/Angel%20LED%20Manual.pdf
dodgeballers_ia is offline   Reply With Quote
Old 09-23-2012, 11:07 AM #3
greatsoccerman
 
 
Join Date: Aug 2012
i have the manual on my phone. but and i know how to charge it. but its when i turn it on it wont come on. i hoping to find someone in arkansas that knows about angels so they can look at it. i know it would be easier to find out the problem if someone was looking at it.
greatsoccerman is offline   Reply With Quote
Old 09-23-2012, 11:17 AM #4
dodgeballers_ia
 
 
dodgeballers_ia's Avatar
 
Join Date: May 2006
Location: IOWA
dodgeballers_ia is BST Legit
dodgeballers_ia supports Team VICIOUS
dodgeballers_ia supports Team VICIOUS
dodgeballers_ia supports Team VICIOUS
Let it charge w/ the swith facing backwards as someone might have turned it around. Or worst case the solenoid is bad, http://www.ebay.com/itm/Angel-LED-Re...em45ffaa a0de and that's the only way to get the solenoid.
dodgeballers_ia is offline   Reply With Quote
Old 09-23-2012, 02:51 PM #5
greatsoccerman
 
 
Join Date: Aug 2012
so if the battery will charge but the gun will just not come on its probably the solenoid?
greatsoccerman is offline   Reply With Quote
Old 09-23-2012, 09:51 PM #6
freak .689
 
 
freak .689's Avatar
 
Join Date: Jan 2006
any lights coming on?
solenoid has nothing to do with it if the lights arent coming on. That could be a bad board.

Check ALL the connection/ribbons/ wires and make sure they are all intact and not clamped, or frayed

NOW IF THE LIGHTS ARE ON*******
AND THE GUN DOES NOT CYCLE, THEN ITS THE NOID, OR LPR
freak .689 is offline   Reply With Quote
Old 09-23-2012, 10:58 PM #7
greatsoccerman
 
 
Join Date: Aug 2012
the lights came on with the old battery the little green one. then we changed the battery and we did it wrong. i left it charging all thro the night and the light on the charger was still red. then we redid the battery and now the light will turn green on the charger but when i go to turn on the gun nothing at all. no clicks no lights nothing. so i think the battery is ok since it seems to be charging. the wires on the gun do seem pretty old lik they could be replaced. but it looked liek the noid set had everything already done.
greatsoccerman is offline   Reply With Quote
Old 09-24-2012, 10:25 AM #8
huntergullett
 
 
huntergullett's Avatar
 
Join Date: Aug 2010
huntergullett owns a Planet Eclipse Ego
Sometimes Angels work best when there is a full moon out
__________________
Tha Hunna Stunna #21

Arkansas Razorbacks Paintball
Point Blank
RK Alumni
huntergullett is offline   Reply With Quote
Old 09-24-2012, 07:36 PM #9
freak .689
 
 
freak .689's Avatar
 
Join Date: Jan 2006
I think you fried the board man, since the battery was put in wrong.
Those guns were older and didn't have a REVERSE POLARITY DIODE installed, which basically doesn't let the battery charge if the battery is reversed. But by you putting it on the charger all night in reverse, if fried the board.

Kinda like putting the wrong terminals on a car battery.

check around the nation for a new board.
freak .689 is offline   Reply With Quote
Old 09-24-2012, 08:18 PM #10
greatsoccerman
 
 
Join Date: Aug 2012
Makes sense. Do they not make boards for them anymore? ANd if so or not would it be easier to get a board for 9v batteries?
greatsoccerman is offline   Reply With Quote
Old 09-26-2012, 01:33 PM #11
freak .689
 
 
freak .689's Avatar
 
Join Date: Jan 2006
Dont think they make boards anymore, check on the nation in the BST FOURM.
OR EBAY.
freak .689 is offline   Reply With Quote
Old 10-11-2012, 08:57 AM #12
comegetsome123
 
 
Join Date: Oct 2012
what about this board? http://www.fixmyangel.com/product_in...products_id=39
comegetsome123 is offline   Reply With Quote
Old 10-12-2012, 07:43 AM #13
rooster_2010
 
 
Join Date: Feb 2010
Look around the nation you can take a stock pm7 or Pmd board from the non ul frame and make it work in most old led angels several guys have done so to make their guns PSP legal. Dr Strangelove is the person to talk to on most of this. Hope this helps. It also gives you a 9v conversion.
rooster_2010 is offline   Reply With Quote
Old 10-12-2012, 09:32 AM #14
comegetsome123
 
 
Join Date: Oct 2012
awesome thanks
comegetsome123 is offline   Reply With Quote
ReplyRegional Ups


Thread Tools

Posting Rules
Forum Jump