Get a piece of metal probably 1" by 7 or 8" And just bend it... I used a press, and it turned out good... the only problem is it was too much of drop and wouldnt fit in my case for the gun... so I took it off...
most hardware stores sell alum and steel stock.. i recomend getting stainless steel rather than alum for the drop.. for one alum dosnt bend as well and when you do bend it it degrades the structure of the metal.. and also it oxidizes rather quickly if not anodized. the stainless will be stronger and look better in the long run.
my freind just took a 2X4 and screwed it into the bottum of the gun (u know were the 2 holes are on the grip) and just screwed in the bottum line to the other side and spray painted it black to match the gun.
Sit and think for a while and you'll realize that you'll still die.
If you're not thinking at all I don't know why you're alive.
yea usualy they sell the metal stock in 1,2 and 4 foot lengths. obviously you willl have to cut it to size but its not hard at all. just make sure its thick enough gage so that it wont bend with normal use.