To finish put the screw in, I used a hex head screw and pipe tape to keep it from backing out. Then just put your trigger in and and the frame back on. Screw the hex in until the gun dose not shoot anymore then back it off a 1/2 turn!
I think it would be pretty hard to ruin the gun using this mod.
If you do not like how it shoots you can take out the screw!
When my brother shoots it I have had people ask me on more than one occasion: was he shooting an electronic. you can shoot the stock just as fast but this makes it easier. e-mail me if you still need more info about the set screw
DarkStar....U DA MAN!....i did this mod to my fish and i screwed it up......it works, but instead of the whole screw being under the trigger its half and half....it works though!!!....the only thing im worried about is me pulling too hard, and the metal screw breaking or deforming the plastic trigger....im looking for an aluminum trigger, With out having to buy a new frame!
Take somthing thin like a credit card, cut a very small peice of it and glue it to the trigger frame. Were you ask well it would be right were the top front of the trigger meets the frame. You glue the peice just in front of the slot the trigger comes through the frame. This is not adjustable and if you dont use some sturdy glue it will probaly fall off. Also you might need it thicker or thinner than a credit card width.
P.S. If you shoot a gun enough your fingers will get used to only pulling as far as is needed to trigger the sear!