Hey guys, a little new to the forum but I haven't found a solution for this problem so here.
I've been trying to resurrect my tigershark, which hasn't been used in a couple of years. I did all the standard stuff, replaced all the O-rings and lubed it up real nice.
buuut, when I try to put air into it, it leaks out the long tube (which goes from the valve through the bolt)
At first I found that the cup seal was unscrewing every time I put air in, so I locktited it. Then when I put air into the gun it would just leak out the overflow.
I'm out of ideas, so I hope someone on here might have some new ones