SOooo i got the grips, and there is some mod's that you will need to do in order for them to look good. brand new out of the box the fit, but what i did is i cut the center piece out that wraps around the frame. after that i got one side and placed the stock grips over and traced. Oh and i used a xactoknife. AND with these grips you will have to use different screws. stock are a little to short but i have gottn a couple through.
while going threw that you will see that there is a piece of sheetmetal in the middle, i have a grind stone spinning wheel so i just sanded that off, dremel would also work great.
after grinding off that i got a file and just smoothed the sheetmetal off. now they look great!
here is what they look like if you dont really cut them.
they hang off the side of the gripframe and dont look great.
With them both on they are slightly thicker then the stock ones but they still feel great.